S4 Sedan L5-2226cc 2.22L DOHC Turbo (AAN) (1992)
Front Bumper: Service and Repair
Front Bumper Assembly
Front bumper assembly, removing and installing
WARNING!
DO NOT re-use any fasteners that are worn or deformed in normal use. Many fasteners are designed to be used only once and become
unreliable and may fail when used a second time. This includes, but is not limited to, nuts, bolts, washers, self4ocking nuts or bolts,
circlips, cotter pins. For replacements always use new parts.
1 - Trim strip, right side
‹› Removing ~ Fig. 1
2 - Bolt w/washer
2.5 Nm (22 in lb)
3 - Trim strip, center
‹› Removing ~ Fig. 1
Adjusting:
-
Remove bumper
-
Loosen bolt -4-
Installing:
-
Align to both side trim strips
4 - Bolt w/washer
2.5 Nm (22 in lb)
5 - Trim strip, left side
‹› Removing ~ Fig. 1
6 - Expanding nut
7 - Guide piece, left/right
‹› Unclip bumper from guide piece
‹› Push bumper end downward out of guide piece
8 - Bolt w/washer
1.5 Nm (13 in lb)
9 - Bracket
10 - Nut
‹› 25 Nm (18 ft lb)
‹› Locks with nut w/washer -11-
11 - Nut w/washer