audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Power Seat With Memory - Troubleshooting|Page 16 > < Power Door Lock Control Module|Testing and Inspection
Page 1
background image

Power Seat Control Module: Technical Service Bulletins
Power Seat With Memory - Troubleshooting

Group: 72

Number: 92-02

Date: April 30, 1992

Subject:
Power Seat with Memory, Troubleshooting

Model(s): 
100 CS, S4

1992 m.y.

(Supercedes Technical Bulletin 91-05, dated December 31, 1991)

Power seat with memory, troubleshooting

Note

^

always refer to appropriate wiring diagram

^

leave driver's door open when checking operation of the driver's seat memory function

^

if defective components are found when carrying out the following test steps, the wiring to these components must also be checked

^

if the battery is disconnected, programmed seat positions remain in memory

Programmed seat positions can only be erased by the input of new seat positions.

^

actuators are mounted on adjustment motors

^

check all actuators before replacing a defective actuator

^

when checking the sender unit for backrest adjustment, do not recline the backrest more than 350

Test conditions

^

battery OK

^

fuse 8 OK

^

circuit breaker S44 for driver's seat, located in position B1 on auxiliary relay panel 1 OK

^

circuit breaker S80 for passenger seat, located in position B2 on auxiliary relay panel 1 OK

Tools required

^

digital multimeter Fluke 83 (US 1119)

Power Seat With Memory - Troubleshooting|Page 16 > < Power Door Lock Control Module|Testing and Inspection