S5 Quattro Coupe V8-4.2L (CAUA) (2009)
/Page-2053001.png)
Front Bumper Reinforcement: Service and Repair
Left Impact Member Mount
Left Impact Member Mount
Removing
-
Remove front bumper cover. Refer to => [ Front Bumper Cover ]. See: Service and Repair/Front Bumper Cover
-
Remove the side impact bar. Refer to => [ Impact Member ]. See: Service and Repair/Impact Member
-
Remove the headlamp washer system spray nozzle.
-
Mark the installation position of the mount to the lock carrier for installation later.
-
Remove the bolts - arrows -.
-
Remove the locating bolt - 1 -.
-
Tip the impact member mount - 2 - on the lock carrier out and remove it.
Installation
‹› Tightening specifications, refer to => [ Impact Member Assembly Overview ] See: Service and Repair/Impact Member Assembly Overview
Installation is reverse of removal, but note the following:
-
Tighten the impact member mount according to the marking made during removal.
-
Install the headlamp washer system spray nozzle.
-
Install the impact member. Refer to => [ Impact Member ]. See: Service and Repair/Impact Member
-
Install the front bumper cover. Refer to => [ Front Bumper Cover ]. See: Service and Repair/Front Bumper Cover
