S5 Quattro Coupe V8-4.2L (CAUA) (2009)
-
Unclip the stop rails using a screwdriver.
-
Remove the bolt - 2 -.
-
Pry the rear lid trim - 1 - out using a Pry Lever (80 - 200) - arrows -.
-
Disengage the rear lid trim at the hinges and remove it.
Vehicles with an emergency release inside the luggage compartment:
-
Disengage rear housing on operating lever handle recess.
Installing
Installation is reverse of removal, but note the following:
‹› If the trim clamps remain in the rear lid mounting points, remove them and insert them in the trim.
‹› Check clamps for damage or deformation, replace if necessary.
-
Position the rear lid trim and press it on until it engages audibly.
Tightening specifications, refer to => [ Rear Lid Trim Assembly Overview ] See: Interior Moulding / Trim/Trim Panel/Service and
Repair/Luggage Compartment Trim Overview.