S5 Quattro Coupe V8-4.2L (CAUA) (2009)
/Page-2261002.png)
Tightening specifications: => [ Upper Transverse Link, Tie Rod, Coil Spring, Lower Control Arm and Level Control System Sensor, Assembly
Overview ] See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Rear Suspension/Upper Transverse Link, Tie Rod, Coil Spring,
Lower Control Arm and Level Control System Sensor, Assembly Overview.
‹› Bonded rubber bushings can only be turned to a limited extent. Only tighten suspension bolts when vehicle is in curb weight or control position.
‹› Lifting to curb weight position=> [ Lifting to Curb Weight Position ] See: Steering and Suspension/Suspension/Service and Repair/Rear
Suspension/Lifting to Curb Weight Position.
-
Insert tie rod - 5 -.
The marking - 3 (Delta) - must be on outside. The tip of marking - 3 - faces up.
-
First insert bolt - 1 - completely and then align it according marking.
-
Insert and tighten bolt - 4 -.
-
Tighten wheel.
-
Vehicle alignment required, see table => [ Wheel Alignment Conditions ] See: Maintenance/Alignment/Service and Repair/Wheel Alignment
Conditions.
Alignment must take place on a VW/Audi recommended alignment stand.
