S5 Quattro Coupe V8-4.2L (CAUA) (2009)
CAUTION!
‹› The bushings cannot be replaced with workshop materials.
‹› If the bushings are damaged, the corresponding assembly parts must be replaced.
Further installation is performed in reverse sequence of removal, but observe the following:
‹› Ensure that electrical connections are pushed in as far as stop and engage with a click.
CAUTION!
Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired correctly, they may
deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
-
Disconnect the battery ground wire with the ignition switched on.
‹› If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.
Tightening specifications, refer to => [ Height Adjustment Motor Assembly Overview ] See: Service and Repair/Removal and
Replacement/Power Standard Front Seat with or without Memory Function
Seat Angle Adjustment Motor
Removing
CAUTION!
‹› Follow the safety precautions for pyrotechnic components.
‹› Before handling pyrotechnic components (e.g. disconnecting the electrical connector), the person handling it must "discharge static
electricity ". This can be done by touching door striker, for example.
-
Switch the ignition on.
-
Disconnect the battery ground cable with the ignition switched on.
-
Remove front seat:
‹› Standard seat, sport seat (power) and comfort seat: => [ Power Standard Front Seats ].