S5 Quattro Coupe V8-4.2L (CAUA) (2009)
/Page-576012.png)
-
Slide combustion chamber seal as far possible onto Assembly Cone (T10133/5) using Assembly Sleeve (T10133/6).
-
Turn Assembly Sleeve (T10133/6) around and slide combustion chamber seal into groove.
‹› When pushing the combustion chamber seal onto the fuel injector, the seal spreads open. This combustion chamber seal must therefore be made
smaller after pushing it on in 2 steps.
-
Press the Sizing Sleeve (T10133/7) with a slight turning motion (approximately 180°) onto the fuel injector until it stops.
-
Pull the Sizing Sleeve (T10133/7) off again, turning it in the opposite direction.
