S5 Quattro Coupe V8-4.2L (CAUA) (2009)
-
Remove assembly device.
-
Place Pull Sleeve (T40048/2) on the crankshaft and slide the shaft seal - 1 - into the sealing surface on the cylinder block.
‹› Leave the pull sleeve for pressing onto the crankshaft.
-
Position the Pull Sleeve (T40048/3) on the crankshaft with 2 M8x55 mm bolts - arrows -.
-
Install bolts by hand.
-
Tighten bolts 1/2 turn each, alternating sides, to press the shaft seal in as far as the stop.
The rest of the installation is in reverse order of removal, note the following:
-
Install the vibration damper with ribbed belt pulley. Refer to => [ Vibration Damper with Ribbed Belt Pulley ] See: Cylinder Block
Assembly/Harmonic Balancer - Crankshaft Pulley/Service and Repair.