S5 Quattro Coupe V8-4.2L (CAUA) (2009)
-
Press the connector release catch - D - - arrow - and remove the connectors - A - and - B -.
Installing
Installation is carried out in the reverse order, when doing this note the following.
‹› When replacing the A/C Control Head Climatronic Control Module (J255) be sure to pay attention to precise assignment. Refer to => [ A/C
Control Modules ] See: Description and Operation/A/C System Control.
Mount the trim to the A/C control head on the Audi Q5.
-
Clean the adhesive surface - D - on the A/C control head - A - for example with cleaning solution D 009 401 04.
-
Install the A/C control head - A -.
‹› The trim piece - B - is supplied with a two-sided adhesive strip already installed - C -.
‹› If the trim piece - B - is going to be reused when replacing the Climatronic Control Module (J255) - A -, A/C control head, the remove the
adhesive strip - C - from the trim - B -. Clean the adhesive surface on the trim - B - as described in the instructions which came with the adhesive
strip. Affix to the trim piece - B - a strip (dimension: 204 mm x 10 mm) of the two-sided adhesive strip - C - with material strength approximately
1.2 mm (for example with adhesive tape D 438 515 A1.
-
Mount the trim piece - B - with the adhesive tape - C - onto the adhesive surface - D - on the A/C control head - A - and the align it - B -.
-
Press the trim piece - B - onto the surface - D -.
‹› After replacing / installing the A/C control head Climatronic Control Module (J255), always perform the follow work. Refer to Vehicle Diagnosis,
Testing and Information System VAS 5051 in "Guided Fault Finding" function.