S5 Quattro Coupe V8-4.2L (CAUA) (2009)
Fuel Gauge Sender: Service and Repair
Fuel Level Sensor 1
Fuel Level Sensor 1
Removing
Proceed as follows:
-
Observe safety precautions => [ Safety Precautions ] See: Powertrain Management/Fuel Delivery and Air Induction/Service Precautions/Vehicle
Damage Warnings/Safety Precautions/Fuel Supply System.
-
Observe rules for cleanliness => [ Clean Working Conditions ] See: Powertrain Management/Fuel Delivery and Air Induction/Service
Precautions/Vehicle Damage Warnings/Clean Working Conditions/Fuel Supply System.
‹› During installation, the cable ties must be re-installed at the same location.
-
Removing fuel delivery unit => [ Fuel Delivery Unit ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pump/Service and
Repair/Fuel Delivery Unit.
-
Disconnect electrical connector - 4 - by pressing release - arrow -.
-
Cut through cable ties - 2 - and free up electrical connector.
-
Release retaining tabs - 1 - and - 3 - and remove fuel level sensor (G) upward.
Installing
Installation is in reverse order of removal, note the following:
-
Insert fuel level sensor (G) in guides on fuel delivery unit and push down until it engages.
-
Connect electrical connector and make sure it engages.
-
Install fuel delivery unit => [ Installing ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pump/Service and Repair/Fuel
Delivery Unit while following the information on connecting the battery.