S5 Quattro Coupe V8-4.2L (CAUA) (2009)
To adapt the Intake Manifold Runner Position Sensor 2 (G512) to the Engine Control Module (ECM) (J623) perform the following steps:
Adaptation requirements
‹› The battery voltage at least 12.5 V.
‹› Coolant temperature must be between 20° C and 80° C.
‹› No DTC's stored in DTC memory.
-
Start the engine and let run at idle for at least 70 seconds.
-
The Engine Control Module (ECM) (J623) will automatically adapt the Intake Manifold Runner Position Sensor 2 (G512).
Assembly is performed in the reverse order of the removal, note the following:
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 01 - 09/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 01 - 09/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.