S5 Quattro Coupe V8-4.2L (CAUA) (2009)
Checking primary voltage
-
Crank the engine.
-
Using a multimeter, check the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) electrical harness connector terminals
3 to 4 for voltage.
Specified value: 0.400 to 0.500 Volts
-
Switch the ignition off.
If the specified value was obtained:
-
Replace the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130).
If the specified value was not obtained:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Replacing ] See: Computers and Control
Systems/Engine Control Module/Service and Repair/Engine Control Module, Replacing.
-
Using a Multimeter, check the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) electrical harness connector terminals