S5 Quattro Coupe V8-4.2L (CAUA) (2009)
16
Subframe
‹› Removing and Installing => [ Subframe with Attachments, ] See: Procedures.
17
Bolt
‹› 115 Nm + an additional 90° turn
‹› Always replace after removal
‹› The bolts must not be loosened or tightened when springs are installed. Release coil springs using spring tensioner before loosening or
tightening.
18
Bolt
‹› 70 Nm + an additional 180° turn
‹› Always replace after removal
‹› Must be tightened in curb weight position => [ Lifting to Curb Weight Position ] See: Service and Repair/Rear Suspension/Lifting to Curb
Weight Position.
19
Nut
20
Lower transverse link
21
Bolt
‹› 70 Nm + an additional 180° turn
‹› Always replace after removal
‹› Must be tightened in curb weight position => [ Lifting to Curb Weight Position ] See: Service and Repair/Rear Suspension/Lifting to Curb
Weight Position.
22
Nut
‹› 95 Nm
‹› Always replace after removal
‹› Must be tightened in curb weight position => [ Lifting to Curb Weight Position ] See: Service and Repair/Rear Suspension/Lifting to Curb
Weight Position.
23
Eccentric washer
24
Tie rod
25
Eccentric bolt
26
Bolt
‹› 55 Nm
27
Left support
28
Clip
‹› Not installed on all vehicles.
29
Rear final drive
30
Left stone deflector
‹› Not installed on all vehicles.