S5 Quattro Coupe V8-4.2L (CAUA) (2009)
-
Tighten bolt - 1 -.
-
Install brake disc and caliper.
-
Tighten threaded connection between drive axle and wheel hub => [ Drive Axle Bolt, Loosening and Tightening ] See: Transmission and
Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and Replacement/Front Suspension/Drive Axle
Bolt, Loosening and Tightening.
-
On vehicles with automatic headlamp range control system, perform basic setting of headlamps.
-
If vehicle level sensor was removed and installed on a vehicle with electronic damper regulation or if the linkage was loosened, the control
position must be reprogrammed => [ Control Position, Programing with VAS 5051B ] See: Suspension/Suspension Control ( Automatic -
Electronic )/Testing and Inspection.
-
If control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module (J759) must be
re-calibrated => [ Lane Assist Calibration Procedure ] See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist
Systems/Testing and Inspection/Lane Assist Calibration Procedure.
-
Tighten wheel.
-
Vehicle alignment required, see table => [ Wheel Alignment Conditions ] See: Alignment/Service and Repair/Wheel Alignment Conditions.