S5 Quattro Coupe V8-4.2L (CAUA) (2009)
‹› Loosen the clamping screw approximately one turn - do not remove it.
‹› Clamping screw is only accessible in selector lever position " D".
‹› Selector lever must remain in position "D" while clamping screw is loose.
-
Carefully move selector lever lightly toward front and rear without shifting into another selector lever position, this releases the tension on the
selector lever cable.
-
Shift selector lever into "Tiptronic gate".
‹› Do not touch selector lever during the adjustment.
-
Tighten the clamping screw in this position with the socket (T40031) without touching the selector lever.
-
Check shift mechanism. Refer to => [ Selector Mechanism, Checking ] See: Shifter A/T/Testing and Inspection.
If shift mechanism does not function properly after adjusting selector lever cable:
-
Bring selector lever cable into basic setting. Refer to => [ Selector Lever Cable, Basic Setting ] See: Service and Repair/Procedures.