S5 Quattro Coupe V8-4.2L (CAUA) (2009)
/Page-1131003.png)
-
Install old axle shaft bolt in joint as shown in the illustration.
-
Drive joint onto shaft with plastic hammer until circlip engages.
-
Insert 50 grams of axle shaft grease into joint on boot side.
-
Install protective boot on outer joint.
-
Bleed protective joint boot.
-
Make sure protective boot is seated on joint correctly.
-
Protective joint boot must fit in groove and on joint contour.
Install Clamp on 88 mm or 100 mm Outer Joint
-
Engage clamp at first catch by hand.
