S6 V8-4.2L (BBD) (2004)
-
Press piston back into brake caliper housing.
-
To do this, insert floating frame using a screwdriver as shown and press powerfully outward.
-
First use screwdriver to press outer brake pads off brake caliper.
-
Press floating frame firmly in direction of (arrow) until stop.
-
Pry brake pads carefully out of piston and remove brake caliper housing.
Note:
^
Clean brake caliper housing thoroughly before installing new brake pads.
^
Be especially careful to remove any residual adhesive foil on outer brake pads.
Installing
-
Insert lower and upper brake pads in piston.