S6 V8-4.2L (BBD) (2004)
Parking Brake Cable: Service and Repair
AWD
Parking brake cables, removing and installing
All wheel drive vehicles
Note: Parking brake cable adjusting components are located in front of rear lower control arms.
Removing
-
Remove locking component-D-.
-
Counter-hold hex -E- using 13 mm open end wrench and turn adjusting nut-C- in until stop.
-
Slide cable adjuster together.
-
Disconnect parking brake cables from brake calipers.
Note: Be careful not to damage parking brake boot when removing and installing.
-
Loosen bolt -A-.
-
Remove parking brake cables from retainer.