S6 V8-4.2L (BBD) (2004)
/Page-908003.png)
If LED does not blink:
Checking voltage supply
-
Disconnect electrical harness connector (arrow) from Camshaft Position (CMP) Sensor -G40-.
-
Disconnect electrical harness connector (arrow) from Camshaft Position (CMP) Sensor -G163-.
-
Connect multimeter for voltage measurement as follows:
Harness connector
Measure to
Terminal
1
Engine Ground (GND)
-
Switch ignition on.
-
Specified value: about 5 V
-
Switch ignition off.
Checking signal wire
