S6 V8-4.2L (BBD) (2004)
Ride Height Sensor: Service and Repair
Level Sensor (All Wheel Drive), Removing and Installing
Level sensor (all wheel drive), removing and installing
Removing
^
Switch off ignition.
^
Disconnect Ground (GND) strap from battery
^
Unplug connection -1- from level sensor.
^
Remove hex bolt -3-.
^
Remove hex nut-4-.
Be careful not to turn sensor crank by 1800, or else basic adjustment must be made again.
Note: When installing linkage pos. 4- at level sensor, use an 8 mm open-end wrench with dimension -A-, to avoid damaging seal.
^
Dimension -A-: 4 mm
Installing
Note:
^
Make sure that pins at bracket item no. 3 (see arrow) engage in auxiliary frame.
^
Coupling must be vertical.
^
Sensor crank (arm) must point backward and downward.
^
Make sure that bracket and clamp are screwed to flat part of the stabilizer bar.
Rest of installation is reverse of removal.