S6 V8-4.2L (BBD) (2004)
/Page-2852003.png)
Available adjustment shims
Installing determined adjustment shims
^
Loosen plastic nuts of installation device -arrows A- far enough so that the bracket for intermediate bearing -1- has some clearance -a- to stud -2-.
^
Insert determined adjustment shim -1- and swing bracket for intermediate bearing -2- to other side.
^
Place second adjustment shim -4- onto stud -3-.
^
Tighten both plastic nuts of installation device -arrow A- again.
Centering drive shaft lengthwise
^
Slide drive shaft with alignment fixture toward rear to stop.
