S6 Quattro Sedan V10-5.2L (BXA) (2007)
Scuff Plate: Service and Repair
Rear Cross Panel Trim, Removing and Installing
Rear Cross Panel Trim, Removing And Installing
Removing
-
Remove mounting bolt - 1 -.
-
Remove molded insert in spare wheel well - arrows-.
-
Remove nuts - 1 - and - 3 -.
-
Remove rear cross panel trim - 2 - upward - arrows -.
Installing
Installation is reverse of removal, but note the following:
-
Guide rear cross panel securing tabs - 1 - sideways into luggage compartment trim openings - arrows -.
-
Install rubber seal lip over leading edge on rear cross panel trim.
Tightening torque
Component
Nm
Rear cross panel trim on body
2.5