S6 Quattro Sedan V10-5.2L (BXA) (2007)
1
-
Upper A-pillar trim
-
Removal
-
Pry out clips - 4 - in lower area of upper A-pillar trim - 1 - using Trim Removal Wedge 3409.
-
Carefully pry upper A-pillar trim - 1 - up at clips - 2 - (Qty. 2) clips with hook as far as stop using Trim Removal Wedge 3409.
-
Carefully slide upper A-pillar trim - 1 - upward (the clips - 2 - (Qty. 2) are slid into keyhole-shaped opening) and remove upper
A-pillar trim - 1 - from bar piece - 6 - and retaining spring - 5 -.
-
Installing: Installation is performed in reverse sequence of removal, thereby noting the following:
-
Check clips - 2 - (Qty. 2) for damage and deformity.
If clips - 2 - are damaged or deformed, upper A-pillar trim must be replaced.
-
Check clamp - 4 - for damage or deformity.
A damaged or deformed clip - 4 - must be replaced.
-
Before installing upper A-pillar trim - 1 -, ensure clips - 2 - and - 4 - are positioned correctly.
CAUTION: Do not connect side curtain airbag when installing upper A-pillar trim - 1 -.
Ensure upper A-pillar trim - 1 - is held securely.
-
Install door seal lip over upper A-pillar trim - 1 -.
2
-
Clamps, (2x)
-
Replace D-pillar trim if damaged or deformed
3
-
Side curtain airbag
4
-
Clip
-
Replace if damaged or deformed
5
-
Retaining spring
-
Is bar piece component part
6
-
Bar piece