S6 Quattro Sedan V10-5.2L (BXA) (2007)
/Page-1955006.png)
-
Set lower timing chain cover in place, guiding cover at an angle from below onto cylinder block sealing surface and cylinder head.
CAUTION!
When installing, make sure that the cylinder head gaskets do not become damaged. A damaged cylinder head seal must be replaced.
-
Tighten bolts in 6 stages as follows:
The rest of the installation is in reverse order of removal, note the following:
-
Install the transmission-side crankshaft shaft seal. Refer to => [ Crankshaft Seal, Transmission Side ] See: Seals and Gaskets/Crankshaft Main
Bearing Seal/Service and Repair.
-
Install oil filter housing. Refer to => [ Oil Filter Housing ] See: Engine Lubrication/Oil Filter Housing/Service and Repair/Oil Filter Housing.
-
Install intake manifold.
-
Install left and right timing chain covers => [ Installing ] See: Left and Right Timing Chain Covers.
-
Install drive plate. Refer to => [ Drive Plate ] See: Transmission and Drivetrain/Flex Plate/Service and Repair/Drive Plate.
-
After installing the engine, fill with oil and check the oil level.
Tightening Specifications
