S6 Quattro Sedan V10-5.2L (BXA) (2007)
Fuse Block: Service and Repair
Coupling Station, Right A-Pillar Trim
Coupling Station, Right A-Pillar Trim
Removing
-
With ignition switched off, disconnect battery Ground (GND) wire. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and
Charging/Battery/Service and Repair/Battery.
-
Remove the lower A-pillar trim.
-
Press clip in - direction of arrow - and disengage coupling station on A-pillar.
-
Unclip fuse panels from coupling station.
-
Remove relay or control modules, then unclip respective relay carrier.
‹› For the exact assignment of coupling station on right A-pillar, refer to the current wiring diagram Wiring diagrams, Troubleshooting & Component
locations.
Installing
Install in reverse order of removal, observing the following:
-
Install the lower A-pillar trim.
-
Connect battery. Required actions => [ ] See: Starting and Charging/Battery/Service and Repair/Battery.