S6 Quattro Sedan V10-5.2L (BXA) (2007)
‹› Ground (GND) connections between engine/transmission/chassis OK.
‹› Exhaust system between catalytic converter and cylinder head properly sealed.
‹› Coolant Temperature at least 80° C.
Function test
-
Perform the function test located in diagnostic mode 06. Refer to => [ OBDMID 05 ($05): Oxygen Sensor
Monitor Bank 2 - Sensor 1 ] See: Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 06 - Read Test
Results For Specific Diagnostic Functions.
If specified values are obtained:
-
End diagnosis and switch the ignition off.
If the specified values are not obtained:
Procedure
-
Raise the vehicle.
-
Loosen the quick release fasteners - 1 - and - 2 - and remove the noise insulation panel.
-
Remove the screws - arrows - and the oxygen sensor electrical harness connector heat shield.