S6 Quattro Sedan V10-5.2L (BXA) (2007)
Leak Detection Pump: Service and Repair
Leak Detection Pump
Removing
‹› All cable ties which are opened or cut open when removing, must be replaced in the same position when installing.
-
Remove left rear wheel.
-
Remove rear left wheel housing liner.
-
Remove ventilation hose - 1 -.
-
Remove nuts - arrows -.
-
Disengage diagnostic pump with bracket.
-
Disconnect electrical harness connector - 3 - with ignition switched off and free up wire - arrow -.
-
Cut the cable ties - 1 - and disconnect the hose - 2 -.
Installing
‹› Assembly overview, refer to => [ EVAP Canister System/Leak Detection System Assembly Overview ] See: Service and Repair/EVAP Canister
System/Leak Detection System Assembly Overview.
‹› Tightening specifications, refer to => [ Fastener Tightening Specifications ] See: Fuel Delivery and Air Induction/Specifications/Fuel Supply
System - Fastener Tightening Specifications.