S6 Quattro Sedan V10-5.2L (BXA) (2007)
Switch the ignition on.
-
Using a Multimeter, check the Intake Manifold Runner Position Sensor 2 (G512) electrical harness connector for voltage.
Switch the ignition off.
If the specified values are obtained:
-
Replace the Intake Manifold Runner Position Sensor 2 (G512).
If specified values are not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) 2 (J624). Refer to => [ Engine Control Module, Removing and Installing ] See: Computers and
Control Systems/Engine Control Module/Service and Repair/Engine Control Module, Removing and Installing.