S6 Quattro Sedan V10-5.2L (BXA) (2007)
Check voltage supply for Fuel Pump (FP) (from Fuel Pump (FP) Control Module J538)
-
Remove rear seat bench.
-
Unbolt cover for right locking flange - arrows -.
-
For voltage testing, connect the hand multimeter V.A.G 1526C with measuring probes and connector adapters from the connector test set V.A.G
1594C between clamp -1 -and - 5 -, as shown in the illustration. The electrical connection remains connected.
NOTE: Connector sockets are numbered respectively on the rear side of the connector.
-
Start engine.
-
Specified value at start and in idle: 4 to 5 V.
-
Depress accelerator pedal completely and then release it (brief throttle burst).
-
Specified value: The voltage value must first rise slightly, then fall and then rise again to the value previously read.
If the reading does not result as described:
-
Check voltage supply and activation of Fuel Pump (FP) Control Module J538.
Check voltage supply for Fuel Pump (FP) Control Module J538
-
Remove Fuel Pump (FP) Control Module J538.
-
Disconnect electrical harness connector - arrow - on Fuel Pump (FP) Control Module J538.