S6 Quattro Sedan V10-5.2L (BXA) (2007)
-
Crank the engine.
Specified value: battery voltage.
-
Switch the ignition off.
If specified value was not obtained:
-
Check the Mass Air Flow (MAF) Sensor 2 (G246)/Intake Air Temperature (IAT) Sensor 2 (G299) electrical harness connector terminal 2 to the
Engine Component Power Supply Relay (J757) socket 2/87 for an open circuit.
Specified value: 1.5 ohms max.
If no malfunction is detected in the wiring and if the voltage supply was OK:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) 2 (J624). Refer to => [ Engine Control Module, Removing and Installing ] See: Computers and
Control Systems/Engine Control Module/Service and Repair/Engine Control Module, Removing and Installing.
-
Using a multimeter, check the Mass Air Flow (MAF) Sensor 2 (G246)/Intake Air Temperature (IAT) Sensor 2 (G299) electrical harness connector
terminals to the Engine Control Module (ECM) 2 (J624) electrical harness connector T94b terminals for an open circuit.