S6 Quattro Sedan V10-5.2L (BXA) (2007)
Specified value: about 5.0 V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Removing and Installing ] See: Computers
and Control Systems/Engine Control Module/Service and Repair/Engine Control Module, Removing and Installing.
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor (G40) electrical harness connector to the Motronic Engine Control Module
(ECM) (J623) electrical harness connector T60a for an open circuit.
Specified value: 1.5 ohms Max.