S6 Quattro Sedan V10-5.2L (BXA) (2007)
-
Remove the screws - 2 - and - 4 -.
-
Remove the lane change assist control module - 1 - from the mount on the bumper - arrow -.
Installing
Install in reverse order of removal, observing the following:
‹› When installing, install cable ties at same location.
-
Install rear bumper cover. Refer to=> Body Exterior 63 Removal and Installation.
If the bumper cover was removed, the lane change assistance control module (J769)/ (J770) must be calibrated again. Refer to=> [ Lane Change
Assistance, Preparing for Calibration ] See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Lane Change Assistance, Preparing for Calibration.
-
Install the rear lid trim panel.