S6 Quattro Sedan V10-5.2L (BXA) (2007)
‹› The Throttle Valve Control Module 2 (J544) is shown. The Throttle Valve Control Module (J338) is similar.
Checking internal resistance
-
Using a multimeter, check the Throttle Drive (for Electronic Power Control (EPC)) (G186) at the Throttle Valve Control Module (J338) terminals
3 to 5 for resistance.
Specified value: 1.0 to 5.0 ohms (at 20° C)
If the specified value was not obtained:
-
Replace the Throttle Valve Control Module (J338).
If the specified value was obtained:
Checking voltage
-
Using a Multimeter, check the Throttle Valve Control Module (J338) electrical harness connector terminals 2 to 6 for voltage.
Specified value: at least 4.5 V
-
Switch the ignition off.
If the specified value was obtained:
-
Replace the Throttle Valve Control Module (J338).
If the specified value was not obtained: