S6 Quattro Sedan V10-5.2L (BXA) (2007)
Tire Pressure Module: Service and Repair
Tire Pressure Monitoring Control Module 1
Tire Pressure Monitoring Control Module 1
Removing
The tire pressure monitoring control module (J502) is located under the glove compartment.
Before removing control module, read out code using Guided Fault Finding in "Replace control module" function.
-
Remove cover - A - from the lower glove compartment cover - B -.
‹› The cover - A - is secured by 4 retainers in the lower glove compartment cover - B -. These retainer can be difficult to remove, therefore be careful
not to damage them when removing the lower glove compartment cover - B -.
-
Unclip control module - 1 -.
-
Disconnect connector - 2 - and remove control module.
Installing
Installation is in reverse order of removal.
-
If Tire Pressure Monitoring Control Module (J502) is replaced, system must be recoded. Refer to => [ Tire Pressure Monitoring System Usage ]
See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Description and Operation/Tire Pressure Monitoring System
Usage.