S6 Quattro Sedan V10-5.2L (BXA) (2007)
-
Lay headliner on seats.
-
Disconnect electrical connection to gas generator - 6 - => [ Electrical connection on gas generator, disconnecting and connecting ].
-
Remove screws - 2 - on side curtain airbag - 1 - beginning at rear.
-
Remove screws - 5 - on gas generator - 6 -.
-
Unclip retainer strap - 4 - securing pins - 3 - from body => [ Unclip retaining strap with airbag securing pin and press ].
-
Disengage gas generator - 6 - with hooks on body => [ Disengaging and engaging gas generator ].
-
Remove head-level airbag - 1 - from vehicle.
‹› Installing
CAUTION!
Always follow side curtain airbag installation procedure.
‹› Replace self-locking nuts and screws when assembling.
‹› Threaded holes for screws must always be cleaned (for example, with thread cutter)
-
Engage gas generator - 6 - with hooks in body => [ Disengaging and engaging gas generator ].
-
Tighten screws - 5 - on gas generator - 6 -.
-
Press retaining strap - 4 - securing pins - 3 - in body => [ Unclip retaining strap with airbag securing pin and press ].
-
Tighten bolts - 2 - in - A -, - B -, - X - and - C to E -, - Y - sequence.
-
When connecting electrical connector to gas generator - 6 -, ensure this engages with a click on gas generator => [ Electrical connection on gas
generator, disconnecting and connecting ].
-
Install headliner => [ Headliner ] See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Trim.
CAUTION!
No one should be in vehicle when connecting battery.
-
Connect battery ground strap.
-
Follow measures after connecting battery =>.
‹› If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and then checked
again.
2
Screws - 4 Nm
‹› Self-locking
‹› Replace
‹› Qty. 7
‹› Threaded holes for screws must always be cleaned (for example, with thread cutter)
3
Securing pin
‹› To secure retaining strap
‹› Qty. 10
4
Retaining strap with securing pin
‹› For securing side curtain airbag to body