S6 Quattro Sedan V10-5.2L (BXA) (2007)
/Page-5506005.png)
‹› Do not damage switchable belt load limiter connector and wire when installing seat belt.
‹› Ensure that electrical connections are pushed in as far as stop and engage with a click.
-
Switch on ignition.
CAUTION!
Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired correctly, they may
deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
-
Connect battery ground cable with ignition switched on.
-
If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again
=> Vehicle Diagnosis, Testing and Information System (VAS 5051B).
Tightening specifications => [ Front Three-Point Seat Belt with Belt Tensioner and Switchable Force
Limiter, from 08.2006, Assembly Overview ] See: Testing and Inspection/Seat Belts
