S6 Quattro Sedan V10-5.2L (BXA) (2007)
Discharge Air Temperature Sensor / Switch: Service and Repair
Right Vent Temperature Sensor
Right Vent Temperature Sensor
Removing
-
Switch off ignition.
-
Remove glove box.
-
Remove right lower center console cover.
-
On the right side remove the holder for the instrument panel - A - and the screws - C -.
-
Remove the air duct to the front passenger's footwell vent - B -.
-
Mark connector - A - to the Right Vent Temperature Sensor (G151) (danger of interchange with other connectors of same construction).
-
Disconnect connector - A - from the Right Vent Temperature Sensor (G151).
-
Rotate the Right Vent Temperature Sensor (G151) - B - approximately 90° in direction of arrow.
-
Remove the Right Vent Temperature Sensor (G151) - B - from the A/C unit.
Installing
Installation is carried out in the reverse order, when doing this note the following.