S6 Quattro Sedan V10-5.2L (BXA) (2007)
Checking voltage supply
-
Using a multimeter, check the Mass Air Flow (MAF) Sensor (G70)/Intake Air Temperature (IAT) Sensor (G42) electrical harness connector
terminal 2 to engine Ground (GND) for voltage.
-
Crank the engine.
Specified value: battery voltage.
-
Switch the ignition off.
If specified value was not obtained:
-
Check the Mass Air Flow (MAF) Sensor (G70)/Intake Air Temperature (IAT) Sensor (G42) electrical harness connector terminal 2 to the Engine
Component Power Supply Relay (J757) socket 2/87 for an open circuit.
Specified value: 1.5 ohms max.
If no malfunction is detected in the wiring and if the voltage supply was OK:
Checking electrical circuit
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Removing and Installing ] See: Powertrain