S6 Quattro Sedan V10-5.2L (BXA) (2007)
-
Remove hex nut - 2 -.
-
Remove hex bolt - 1 -.
-
Remove level control system sensor.
Installing
Installation is in reverse order of removal. Observe the following when doing so:
Guide retaining hook on the sensor bracket into the subframe.
Sensor lever must point toward front.
Tightening specifications. Refer to => [ Track Control Arm, Guide Link and Level Control System Sensor Assembly Overview ] See: Front
Suspension
-
Re-adapt control position. Refer to => [ Control Position, Programming ] See: Steering and Suspension/Suspension/Suspension Control (
Automatic - Electronic )/Testing and Inspection/Programming and Relearning/Control Position, Programming.
-
Perform headlamp basic setting.
-
Calibrate lane assist. Refer to => [ Calibration Procedure ] See: Maintenance/Alignment/Testing and Inspection/Component Tests and General
Diagnostics/Calibration Procedure