S6 Quattro Sedan V10-5.2L (BXA) (2007)
/Page-4297002.png)
This position can be simulated on the lifting platform by raising the wheel bearing housing using engine/transmission jack VAG 1383 A and wheel
hub support T10149.
Requirement:
^
Engine must be installed.
-
Set vehicle on lifting platform.
-
Perform system bleed using VAS 5051 A.
-
Remove bolt - 1 - and pull wheel house liner aside.
-
Slowly loosen air line - 1 - for connection - 2 - and let air pressure dissipate. Once air pressure has dissipated, remove air line.
-
Seal both connections. When doing this, make sure that no particles of dirt penetrate into the connections.
-
Turn wheel hub far enough until one of the holes for wheel bolts is on top.
-
Install wheel hub support T10149 with wheel bolt.
-
Insert wheel hub support T10149 into engine/transmission jack V.A.G. 1383 A and press wheel bearing housing far enough upward until control
position, dimension - a -, is obtained.
Control position
^
Dimension - a - for vehicles with air suspension 384 mm
