S6 Quattro Sedan V10-5.2L (BXA) (2007)
Alignment: Removal and Replacement
Adaptive Cruise Control Sensor
Adaptive Cruise Control Sensor
The sensor is located behind the radar cover on the front bumper.
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1783)
Removing
-
Remove front bumper cover.
-
Disconnect connector - arrow -.
-
Remove hex bolts - 1 -.
-
Remove ACC sensor.
Installing
Installation is in reverse order of removal. Observe the following when doing so:
‹› Studs in bracket are preset. If necessary, correct adjustment.
-
Place sensor on a soft and clean surface.
Measure dimension - a - of all studs.