S6 Quattro Sedan V10-5.2L (BXA) (2007)
‹› 110 Nm
‹› Always replace after removal
‹› After loosening threaded connection of track control arm to wheel bearing housing, adhesive residue must be removed on thread of linkage
stub.
6
Nut
‹› Always replace after removal
7
Bolt
‹› 40 Nm plus an additional 90° turn
‹› Always replace after removal
8
Shock Absorbers
9
Bolt
‹› 90 Nm plus an additional 90° turn
‹› Always replace after removal
10
Stabilizer bar
11
Self-locking nut
‹› 8 Nm
‹› Always replace after removal
12
Control Arm
‹› Removing and installing, refer to => [ Track Control Arm ] See: Suspension/Control Arm/Service and Repair/Removal and Replacement/Front
Suspension/Track Control Arm
‹› Replacing bearings for track control arm, refer to => [ Control Arm Bearing ] See: Suspension/Control Arm/Service and Repair/Removal and
Replacement/Front Suspension/Control Arm Bearing
13
Left or right front level control system sensor G78 or G289
‹› Only remove and install or replace completely => [ Front Level Control System Sensor ] See: Front Level Control System Sensor
‹› The sensor lever must point forward.
‹› After loosening, check basic setting of headlamp adjustment.
‹› After loosening, control position must be adapted again in vehicles with air spring suspension, refer to => [ Control Position, Programming ]
See: Suspension/Suspension Control ( Automatic - Electronic )/Testing and Inspection/Programming and Relearning/Control Position,
Programming.
14
Bolt
‹› 5 Nm
15
Securing clip
16
Bolt
‹› 10 Nm
17
Bolt