S6 Quattro Sedan V10-5.2L (BXA) (2007)
Level Control Solenoid Valve: Service and Repair
Solenoid Valve Block, Removing and Installing
Solenoid valve block, removing and installing
Special tools, testers and auxiliary items required
^
Torque wrench V.A.G. 1783
^
Insertion tool 10 mm V.A.G. 1783/1
Removing
Note:
^
Solenoid valve block is installed on right side, behind front bumper.
-
Position vehicle on lifting platform.
-
Perform system bleed using VAS 5051 A.
-
Remove decorative wheel cover, for light-alloy wheels remove protective cap (use pulling hook in vehicle tool kit).
-
Remove wheel.
-
Remove noise insulation.
-
Remove right rear wheel housing liner.
-
Disconnect connector - 1 -.
-
Slowly loosen air lines - arrows - and let air pressure dissipate. Once air pressure has dissipated, remove air lines.
-
Protect air lines from dirt.