S6 Quattro Sedan V10-5.2L (BXA) (2007)
/Page-4900002.png)
-
Coat O-rings - 4 - with grease supplied.
-
Slide Level Control Pump Temperature Sensor - 3 - into housing - 2 - up to stop.
-
Install bolt - 1 - and tighten to specified tightening torque.
-
Connect harness connector - 2 - and clip in electrical wire.
Note:
^
Secure electrical wire only at positions marked - arrows -.
-
Install noise insulation.
-
Install right front wheel housing liner.
-
Install wheel.
-
Position vehicle on its wheels.
-
Tighten wheel.
