S6 Quattro Sedan V10-5.2L (BXA) (2007)
Pressing wheel hub out of wheel bearing with 92 mm diameter
Pressing off bearing inner race of wheel hub with 85 mm diameter or 92 mm diameter
-
Insert separator between bearing inner race - 1 - and spinning washer - 2 - and preload spindle.
Note:
^
Use a commercially available separator, e.g. Kukko 1712.
This deforms the spinning washer and must then be replaced.
-
Press off bearing inner race from wheel bearing with 85 mm diameter or 92 mm diameter of wheel hub.