S6 Quattro Sedan V10-5.2L (BXA) (2007)
/Page-3136004.png)
Note:
^
The ATF inspection plug must be installed again before the ATF reaches a temperature of 45°C (for hot countries 50°C). Allow transmission to
cool and check again.
-
Guide filler hook of ATF filler tool V.A.G. 1924 into opening - arrow - of protective cap, while doing so do not push cap up and in.
-
Add ATF using ATF filler tool V.A.G. 1924 until ATF drips from inspection hole.
Note:
^
If the ATF level is too high or too low it will adversely affect the operation of the transmission.
-
Tighten ATF inspection plug with new seal - arrow - to 80 Nm.
-
Press <- button to end function "08 - Read measured value block".
-
Select "06 - End output".
-
Switch off ignition and disconnect diagnostic connector.
