S6 Quattro Sedan V10-5.2L (BXA) (2007)
/Page-3182002.png)
Note:
^
The shim must be the correct size and must not be replaced by a shim with a different thickness.
-
Remove differential.
-
Remove tapered roller bearing outer race for differential - 1 - and shim - 2 - located behind it from transmission housing by hand.
Note:
^
The shim must be the correct size and must not be replaced by a shim with a different thickness.
-
Remove left drive flange.
-
Remove shaft seal.
Note:
^
Extractor lever must be positioned behind both sealing lips of the shaft seal. Do not position at outer circumference of shaft seal, otherwise the
contact surface in transmission housing will be damaged. Guide the lever carefully when prying the seal.
Installing
-
Examine shaft seal seat in transmission housing for damage; if necessary rework.
-
Coat outer circumference and sealing lip of shaft seal with axle oil.
Note:
^
Push shaft seal onto pressure piece so that the projecting sealing lip of seal faces the tool.
-
Drive in new shaft seal as far as stop.
