S6 Quattro Sedan V10-5.2L (BXA) (2007)
/Page-7590001.png)
Windshield: Service Precautions
Flush-Bonded Windows
Minimum Curing Times
CAUTION:
-
For safety reasons, use only electrically non-conductive 2C-adhesive when installing windshield and rear window using the materials
listed below.
-
Vehicle is only safe for operation after minimum curing time has elapsed and only then may it be used.
Cleaning When Soiled By Adhesive Sealing Material
It is recommended to use adhesive remover D 002 000 10 as a cleaning solution. Observe safety precautions when processing.
NOTE: Part numbers are for reference only. Always check with your Parts Department for the latest part number information
CAUTION: When cleaning from vehicle interior out, the window just installed must not be pressed outward.
Paint Surfaces:
-
First, clean paint surfaces with a dry cloth. Remove residual adhesive with adhesive remover D 002 000 10.
NOTE: Part numbers are for reference only. Always check with your Parts Department for the latest part number information
Plastic Trim:
-
Allow adhesive sealing material to harden (about 1 hour) and then peel off.
