S6 Wagon L5-2226cc 2.22L DOHC Turbo (AAN) (1995)
Rear Bumper Cover / Fascia: Service and Repair
Rear bumper cover, assembly
Note: Bumper cover is secured to bumper by retaining tabs. It will take substantial force to separate.
1 - Trim strip, left
‹› Remove after disassembling bumper -4-
‹› Drill and punch out rivet
2 - Pop-rivet
3 - Trim strip, right
‹› Remove after disassembling bumper -4-
‹› Drill and punch out rivet
4 - Bumper
To remove:
-
Remove bumper assembly
-
Drill out pop-rivets ~ Fig. 1
-
Pry out trim strips from bumper
-
Pry out bumper cover from lower edge of bumper ~ Fig. 3
-
Pry bumper from cover
5 - Bumper cover
‹› Remove bumper assembly
‹› Removing ~ Fig. 3
6 - Pop-rivet
‹› When installing bumper to bumper cover, use rivets with offset or add a washer ~ Fig. 2