S6 Wagon L5-2226cc 2.22L DOHC Turbo (AAN) (1995)
Front Door Window Motor: Service and Repair
Removing
NOTE: Window regulator motor may be removed with door component carrier installed.
-
Remove door trim panel.
-
Remove Torx screws (arrows).
-
Disconnect 2- point electrical connector.
-
Carefully pry out motor, as shown.
Checking
-
Connect motor to a fused 30 amp external power supply and check by operating motor in both directions.
Installing
-
Press motor onto window regulator.
-
Tighten mounting screws diagonally.
Tightening torque: 4.5 Nm (40 in lb)
Install all other components in reverse order of removal.